ITT PumpSmart PS220, Руководство по конфигурации и эксплуатации

Страница: 36 / 300

PS220 Configuration & Operation Guide
35 PS220
SmartFlow
6. Configure the DELTA Z.
The discharge pressure gauges height
above the centerline of the suction.
1. “ARROW RIGHT” to change
2. “ARROWS” to change value
3. “Save”
4. “ARROW DOWN”
5. Configure the Transmitter(s) and the associated Analog
Inputs to be used for the TDH calculations.
Notes:
1. If you have already used the Process Control Wizard, a suction or discharge pressure transmitter will be shown as
PROC TRANS1. There is no need to re-configure these. Please move on to the next screen.
An unused Analog Input (AI) will need to be used for either of these 2 choices to function correctly. Please check
the settings of the Analog Inputs currently in use by going to: Menu>PARAMATERS> Complete List>Scroll down to
Group 76>Select and View 76.01&02. If available, they will show “NOT SELECTED”. You may have to add an Exten-
sion Card to use additional inputs. (Not provided as standard
Note:
1. There are 2 selection choices for this setup:
2. A simple “Yes” or “No” response will allow you to continue through various steps.
Selection 1. Configure the use of a Differential Pressure Transmitter. This wizard will completely configure the
instrumentation required for use.
1. “ARROW DOWN”
2. “Yes” 1. “Select” 1. “ARROW DOWN”
2. “SAVE”
1. “Next” 1. “ARROW DOWN” to the AI
to be used.
2. “ARROW RIGHT” 1. Select “DIFF PRESS”