ITT PumpSmart PS220, Руководство по конфигурации и эксплуатации

Страница: 49 / 300

PS220 Configuration & Operation Guide
PS220 48
Process Control
1. Configure the sleep Mode.
The choices are:
1. Off. Disable the Sleep function.
1. “ARROW RIGHT” to change
2. “ARROWS UP/DOWN” to change value
3. “Save”
2. Min Speed is the default setting. When set properly the drive will sleep as described above. With this choice
the pump will sleep when the 3 values of “Sleep Value”, “Minimum Speed”, and the “Sleep Delay” have all been
achieved. A Dead Head test is strongly recommended to be performed to correctly set the minimum speed. Refer
to Dead Head in this manual.
Note: If using “Minimum Speed” for use in the “Alarm & Control Pump Protection Response” Min Speed Sleep is
not an available choice. See “Intelligent Sleep”
Additional Wizards will need to be run when configuring the Intelligent Sleep selection to function correctly:
1. SmartFlow Wizard if being used for this value for flow.
2. Pump & VFD Protection Wizard, if an external flowmeter is used that is not the primary process control
transmitter selected previously.
2. Configure the Sleep Value
1. “ARROW RIGHT” to change
2. “ARROWS” to change value
3. “Save”
4. “ARROW DOWN”