Case 2050M, Руководство оператора, Страница: 119 / 286

4 - OPERATING INSTRUCTIONS
Adjusting maximum hydrostatic drive speed
parameter
To adjust the maximum drive speed, follow the same steps
as for steering sensitivity, then highlight “Max Spd”.
The max drive speed choices are: 9, 11, 13, 15 as se-
lected by the operator, with the default speed set to 15.
The speed can be raised or lowered with the speed but-
tons located on the left joystick.
Adjusting reverse speed ratio differential
setting
To adjust the reverse speed ratio differential, follow the
same steps as for steering sensitivity, then highlight
“RevSpdDiff”.
The RevSpdDiff choices are: -2, -1, 0, +1, +2, +3, and +4.
After selecting and highlighting the desired value, press
the enter switch to confirm the selection. Press the es-
cape switch to store the choice.
This will produce a reverse speed calculated from the for-
ward speed. For example, if “+4” is selected, this will pro-
duce a reverse speed 4 speeds higher than the forward
speed. If “-2” is selected, this will produce a reverse speed
2 speeds slower than the forward speed. If “0” is selected,
the reverse and forward speeds will be the same.
The reverse speed cannot be below 1 and above the “Max
Spd” setting.
Adjusting shuttle parameter
To adjust the shuttle parameter, follow the same steps and
highlight “Shuttle”.
The shuttle choices are:
• Smooth
• Moderate (preset from the factory)
• Aggressive
After selecting and highlighting the desired value, press
the enter/escape switch to confirm the selection. Press
the escape switch to store the choice.
Dual function deceleration or transmission
pedal
The deceleration or transmission pedal can be changed
at the transmission selection.
Highlight “Pedal”, and follow the same steps as for
steering sensitivity. Choose between:
• Decel
• Trans-(factory default)
4-17