8.3 Connecting Peripheral Devices
8.3
Connecting Peripheral Devices
Figure 8.1
illustrates how to configure the drive and motor to operate with various peripheral devices.
• Refer to the specific manual for the devices shown below for more detailed installation instructions.
E n g in e e r in g S o ftw a r e T o o ls
M o ld e d C a s e
C ir c u it B r e a k e r
( M C C B )
a n d /o r
G ro u n d F a u lt
C ir c u it I n t e r r u p t e r
(G F C I)
I n p u t S id e
N o is e F ilte r
M a g n e tic
Z e r o - p h a s e
C o n t a c t o r
R e a c to r
( s w itc h e s to
lin e p o w e r)
F ig u r e 8 .1 C o n n e c ti n g P e r i p h e r a l D e v ic e s
G r o u n d
<1> Ter1 and +2 for connecting a DC choke are available only in units CIM R-LC2A0018 to 2A0075 and CIMR-
LC4A0009 to 4A0039. D rives above have built in DC chokes.
<2> Terminals B1 and B2 for connecting a braking resistor are available only in units CIM R-LC2A0018 to 2A0115 and
CIM R-LC4A0009 to 4A0060.
<3> W hen using an external braking chopper in drives from CIM R-LC2A0018 to 2A0115 and CIM R-LC4A0009 to
4A 0060 connect the chopper to drive term inals B1 and -. W hen using larger drives connect the chopper to terminals
+3 and -.
<4> To obtain the driver and software o f USB Copy Unit, CopyUnitM anager and D riveW izardPlus, access the following
site:
Europe: http://www.yaskawa.eu.com
T
YASKAWA ELECTRIC SIEP C710616 33D YASKAWA AC Drive L1000A Technical Manual
295
P
e
ri
p
h
e
ra
l
D
e
v
ic
e
s
&
O
p
ti
o
n
s