3.6 Digital Operator and Front Cover
3.6
Digital Operator and Front Cover
Detach the digital operator from the drive for remote operation or when opening the front cover to install an option card.
Note: Be sure to remove the digital operator prior to opening or reattaching the front cover. Leaving the digital operator plugged into
the drive when removing the front cover can result in erroneous operation caused by a poor connection. Firmly fasten the front
cover back into place before reattaching the digital operator.
♦ Removing/Reattaching the Digital Operator
■ Removing the Digital Operator
While pressing on the tab located on the right side of the digital operator, pull the digital operator forward to remove it
from the drive.
F ig u r e 3 .1 0 R e m o v in g t h e D igital O p e r a to r
■ Reattaching the Digital Operator
Insert the digital operator into the opening in the top cover while aligning it with the notches on the left side o f the
opening.
Next, press gently on the right side of the operator until it clicks into place.
F ig u r e 3.11 R e a tt a c h in g t h e D ig ital O p e r a to r
♦ Removing/Reattaching the Front Cover
■ Removing the Front Cover
Models CIMR- LD 2A 0018 to 2A0075 and 4A0009 to 4A0039
After removing the terminal cover and the digital operator, loosen the screw that affixes the front cover (model CIMR-
LD2A0047, 4A0024, and 4A0031 does not use a screw to affix the front cover). Pinch inwards on the tabs found on each
side o f the front cover, then pull forward to remove it from the drive.
T
.
F ig u r e 3 .1 2 R e m o v e t h e F r o n t C o v e r (M o d e ls C IM R -L D 2A 0018 to 2 A 0 0 7 5 a n d 4 A 0 0 0 9 to 4A 0039)
YASKAWA ELECTRIC SIEP C710616 33D YASKAWA AC Drive L1000A Technical Manual
53
E
le
c
tr
ic
a
l
In
s
ta
ll
a
ti
o
n