3-3
Section
External I/O Circuitry
28
•
The commons for all outputs are connected to the 24-V output ground.
•
The commons for all inputs except for the 24-V and 5-V origin input signals and
positioning completed input signals are connected to the input common.
•
The common for the positioning completed input signal is connected to the
24-V output power supply via a diode.
•
Use the origin common as a pair with the 24-V origin input signal or the 5-V
origin input signal.
3-3-2 External I/O Connector Arrangement
•
The connectors that are included with this PCU are solder-type connectors.
•
Use wires with cross-sectional areas of 0.2 mm
2
or less.
•
Be careful not to short-circuit neighboring terminals when soldering.
•
Cover the soldered part of the wire with insulation tubing.
Wiring Power Lines
Insulator
Lead
Connector
Connector Pin Numbers
Outline of connector
(rear panel)
Pin number marks
(View from soldered side)
Assembling Connectors Supplied with the PCU
Connector
M2x8 pan-head screws (two)
Case
M2 nut (four)
Cable holder (two)
Screw (two)
M2x6 pan-head screws (two)
Summary of Contents for CS1W-NC113 - REV 02-2008
Page 1: ...CS1W NC113 213 413 133 233 433 Position Control Units ...
Page 2: ...iv ...
Page 4: ...vi ...
