10-3
Section
Direct Operation
256
Designation of the Operating Data Area
The operating data area is allocated to D00500 through D00523 by the data
memory settings. No prior settings are needed for the operating data area
because the data is set in the program.
Data Settings
The values for D20004 onwards are transferred when the power is turned ON (or
at restart).
This data area is not used with direct operation. It should be left entirely at the
default settings (0).
This data area is not used with direct operation. It should be left entirely at the
default settings (0).
This data area is not used with direct operation. It should be left entirely at the
default settings (0).
This data area is not used with direct operation. It should be left entirely at the
default settings (0).
Dwell times are not used in these programs, so this data area needs to be set
completely to the default settings (0).
Zones are not used in these programs, so this data area needs to be set com-
pletely to the default settings (0).
Program
W030 is used as a work word.
Axis Parameters
Positioning Sequences
Speeds
Positions
Acceleration and
Deceleration Times
Dwell Times
Zones
Summary of Contents for CS1W-NC113 - REV 02-2008
Page 1: ...CS1W NC113 213 413 133 233 433 Position Control Units ...
Page 2: ...iv ...
Page 4: ...vi ...
