11-5
Section
Error Code Lists
293
Item
Operation after
error
Clearing
method
Cause
Code
Name
Positioning
sequences
Sequence data
error
3000
to
3099
One of the following errors occurred in
the positioning sequence:
The completion code is not in the range 0
to 6.
The initial speed number is not in the
range 00 to 99.
The acceleration time number is not in
the range 0 to 9.
The deceleration time number is not in
the range 0 to 9.
The target speed number is not in the
range 00 to 99.
The dwell time number is not in the range
00 to 19.
One of the following errors occurred in
the axis designation:
The Y, Z, or U axis was specified for a
1-axis PCU.
The Z or U axis was specified for a 2-axis
PCU.
More than one axis is specified for
interrupt feeding or speed control, or all
axis designation settings are set to 0.
(The last two digits of the code indicate
the position data number (00 to 99)
where the error occurred.)
Transfer the
data again after
checking and
correcting it.
When this error
occurs during
data transfer, all
data (including
the data with the
error) specified
for transfer will
be lost.
All operating
axes will be
decelerated to a
stop.
Dwell times
Dwell time error
4001
to
4019
These codes indicate that a dwell time is
outside the settable range (0 to 9.99 s).
(The last two digits of the code indicate
the dwell time number (00 to 19) where
the error occurred.)
Summary of Contents for CS1W-NC113 - REV 02-2008
Page 1: ...CS1W NC113 213 413 133 233 433 Position Control Units ...
Page 2: ...iv ...
Page 4: ...vi ...
