IBM PC Server 325, User Handbook Manual

Page: 161 / 288

Error Messages
POST Message Description
662 A diskette drive configuration error occurred.
Action: If you removed a diskette drive, make sure the
diskette drive setting is correct in the
Configuration/Setup utility programs. If the setting is
not correct, change the setting. For instructions on
using the Configuration/Setup utility programs, see
Chapter 2, “Configuring Your Server.”
962 A parallel port configuration error occurred.
Action: If you changed a hardware option, make sure the
parallel port setting is correct in the
Configuration/Setup utility programs. If the setting is
not correct, change the setting. For instructions on
using the Configuration/Setup utility programs, see
Chapter 2, “Configuring Your Server.”
11XX A failure occurred during testing of the system-board serial
port.
Action: If you have a modem, serial printer, or other serial
device attached to your server, verify that the serial
cable is connected correctly. If it is, use the following
procedure:
1. Turn off the server.
2. Disconnect the serial cable from the serial port.
3. Wait five seconds; then, turn on the server.
If the POST error message does not reappear, either the
serial cable or the device is probably failing. (See the
documentation that comes with the serial device for
additional testing information.)
If the POST error message reappears, have the system
serviced.
1762 A hard disk configuration error occurred.
Action:
1. Make sure the cables are securely attached to all
drives.
2. Make sure the settings for the drive options are
correct in the Configuration/Setup utility
programs. If the settings are not correct, change
them. For instructions on using the
Configuration/Setup utility programs, see
Chapter 2, “Configuring Your Server.”
178X A failure occurred during testing of the hard disk drive.
Action: Run the diagnostic tests.
Chapter 4. Solving Problems
147