Ethernet Controller Messages
PCNTNW-DOS-58 The board did not respond to the initialization command.
Explanation:
The IRQ setting might be incorrect with the hardware setting, or the
EEPROM might be corrupted.
Action:
Verify that the IRQ settings in the NET.CFG file match the configuration
settings in the Configuration/Setup utility programs. See “PCI Bus Control” on
page 33 for information on setting the interrupt requests. Verify that the EEPROM
on the system board is programmed correctly.
PCNTNW-DOS-61 PCI device IRQ number mismatch.
Explanation:
The IRQ number specified in the NET.CFG file does not match with
the IRQ number assigned in the Configuration/Setup utility programs.
Action:
Remove the IRQ number in the NET.CFG file.
PCNTNW-DOS-64 The device was not found.
Explanation:
The driver cannot find any PCnet device in the server.
Action:
Verify that the Ethernet enable jumper is set to the default (enable) position.
Go to “Running the Ethernet Diagnostics” on page 140 to run the diagnostic utility.
PCNTNW-DOS-65 Device not found at IOADDRESS.
Explanation:
The device was not found at the IO address specified in the NET.CFG
file. The driver cannot find an Ethernet controller in the server.
Action:
Verify that the IO address in the NET.CFG file matches with the with the
board. Otherwise, remove the PORT keyword from the NET.CFG file.
PCNTNW-DOS-67 PCI scan specified, device not found.
Explanation:
The driver cannot locate the Ethernet contoller on the PCI bus.
Action:
Perform the following steps:
1. Verify that the Ethernet enable jumper is set to the default (enable) position.
2. Use the BUSTYPE keyword to specify a value of PCI1.
3. If the problem persists, go to “Running the Ethernet Diagnostics” on page 140 to
run the Ethernet diagnostics.
PCNTNW-DOS-75 Unsupported bus ID specified.
Explanation:
The bus ID number specified in the NET.CFG file is not supported by
Novell.
Action:
Correct the bus ID number in the NET.CFG file.
162
PC Server 325 User's Handbook
Summary of Contents for PC Server 325
