IBM PC Server 325, User Handbook Manual

Page: 151 / 288

About the Test Programs
Changing Selected Tests in Test Groups
To add or remove a test from a Test Group:
1. In the Module Tests Menu, use the Up Arrow (
↑
) or Down
Arrow (
↓
) key to move the highlight bar to your selection.
2. Press Tab to move into the expanded Test Group window.
3. Move the highlight bar to the test you want to select or deselect.
4. Press the Spacebar at the highlighted test to toggle between
select (indicated by a diamond (“
♦
”)) and deselect.
Attention:
An asterisk (*) directly adjacent to an item indicates
that running that test might damage your data. Make sure to
back up all of your data before running the tests.
5. Press Enter.
Creating Test Scripts
Scripting allows you to select specific groups of tests, testing
parameters, and options. You can then save your selections for later
use as a test script.
To set up a test script:
1. Select Diagnostics from the Main Menu; then press Enter.
2. Select Module Tests; then press Enter.
3. Select the test groups and specific tests.
4. Select Save Script (the last item on the Options Menu).
5. Type in a file name. The test program automatically adds the
extension “QA.”
6. To load and run the test program with this test setting, type:
QAPRO /SCRIPT- Filename,R and then, press Enter.
Note: Adding the “,R” runs the tests listed in the named Test
Script. If this is omitted, the diagnostic program loads
only the program with the test settings as previously
saved in the chosen Script File.
Chapter 4. Solving Problems
137