IBM PC Server 325, User Handbook Manual

Page: 187 / 288

Ethernet Controller Messages
pnt0-12 device failed checksum test!
Explanation: The driver cannot find an Ethernet controller.
Action: Perform the following steps:
1. Verify that the Ethernet enable jumper is set to the default (enable) position.
2. Go to “About the Test Programs” on page 129 to run the diagnostic utility.
pnt0-13 add_intr_handler failed! Interrupts already enabled.
Explanation: The IRQ specified or found conflicts with other devices in the system.
Action: Perform the following steps:
1. Modify your hardware settings.
2. Run netconfig to match the hardware settings.
pnt0-14 Cannot locate hardware.
Explanation: The SunSoft Solaris driver cannot find any Ethernet controller.
Action: Perform the following steps:
1. Verify that the Ethernet enable jumper is set to the default (enable) position.
2. Go to “About the Test Programs” on page 129 to run the diagnostic utility.
pntO-15 No more devices to open.
Explanation: The SunSoft Solaris driver cannot find any more Ethernet controllers.
Action: Perform the following steps:
1. Verify that additional IBM PCI Ethernet adapters are present or replace the
Ethernet adapter that fails to respond.
2. Go to “About the Test Programs” on page 129 to run the diagnostic utility.
pntO-17 Device fault... Reset initiated!
Explanation: The SunSoft Solaris driver has been reset due to device fault.
Action:
Perform the following steps:
1. Verify that additional IBM PCI Ethernet adapters are present or replace the PCnet
card that fails to respond.
2. Go to “About the Test Programs” on page 129 to run the diagnostic utility.
pntO-19 IRQ found for PCnet hardware does not match space.c!
Explanation: This is a warning message referring to the IRQ found in the system.
Action: Ignore this message if you are sure that this is what you want to do.
Otherwise, run netconfig to match the hardware settings.
Chapter 4. Solving Problems
173