IBM PC Server 325, User Handbook Manual

Page: 198 / 288

Troubleshooting Other Network Adapters
Troubleshooting Other Network Adapters
This section provides general troubleshooting information for
problems that might occur when a network adapter is installed in
the server. For more specific details about troubleshooting your
network adapter, see your network-adapter documentation.
If the network adapter cannot connect to the network, or if the
network adapter contains LEDs that do not work, check the
following:
Ÿ Make sure that:
– You installed the latest revision levels of the device drivers
that came with the network adapter, as described in your
operating-system documentation.
– The network adapter is seated firmly in the connector (see
“Installing Adapters” on page 63).
– You installed the correct network cable. (If you need
information about selecting the correct cable, contact your
IBM marketing representative or your IBM reseller.)
– The network cable is securely attached at all connections. If
the cable is attached correctly but the problem persists, try a
different cable.
Ÿ Check for operating-system-specific causes for the problem.
Refer to your operating-system documentation and your
network-adapter documentation.
Ÿ
Test the network adapter. The adapter test requirements
depend on which operating system you are using. Refer to your
operating-system documentation and your network-adapter
documentation for details.
Ÿ
If the network adapter fails during testing, remove it and install
another network adapter as described in “Installing Adapters”
on page 63.
184
PC Server 325 User's Handbook