IBM PC Server 325, User Handbook Manual

Page: 259 / 288

Installing the Drawer Model in a Rack
Installing the Server in the Rack
In this section, you will use the following parts:
Ÿ Two screws (10-32 by 0.5-inch long)
Ÿ Two nut clips
Ÿ
Cable ties
Ÿ
Two screws (10-32 by 1.0-inch long)
To install the server into the rack:
1. Position the PC Server 325 horizontally, with the 3.5-inch drive
bays on the top.
2. Align the inner slides on the sides of the server with the slide
rails; then, slide the server onto the outer slide, until the slide
rails click into place.
Note: When the drawer is fully extended, safety latches on the
slide rails lock into place. This prevents the server from
being accidentally pulled out too far and dropped. To
release the safety latch, press in.
3. Press the safety latches and slide the drawer about halfway into
the rack.
Appendix D. Installing a PC Server 325 in a Server Rack
245