IBM PC Server 325, User Handbook Manual

Page: 171 / 288

Ethernet Controller Messages
PCNTNW-NW-127 The local bit in the node address override was set.
Explanation: The local bit in the IEEE address format indicates that the addresses
are being managed locally. If you use the node address override capabilities of this
driver to enter a new address, the local bit should be set. You entered an address
without the local bit set. The driver has set the local bit.
Action: None.
PCNTNW-NW-164 The device was not found.
Explanation: The driver cannot find an Ethernet controller in the server.
Action: Perform the following steps:
1. Verify that the Ethernet enable jumper is set to the default (enable) position.
2. Go to “About the Test Programs” on page 129 to run the diagnostic utility.
PCNTNW-NW-164 Device not found at IOADDRESS.
Explanation: The Ethernet controller cannot be found at the IO address specified in
the NET.CFG file.
Action: Verify that the IO Address in the NET.CFG file matches with the board.
Otherwise, remove the PORT keyword from the NET.CFG file.
PCNTNW-NW-167 PCI scan specified, device not found.
Explanation: The driver cannot locate the Ethernet controller on the PCI bus.
Action: Perform the following steps:
1. Verify that the Ethernet jumper on the system board is set to the default, enable
position.
2. Edit the NET.CFG file to change the BUSTYPE keyword to PCI1.
3. If the problem persists, go to “About the Test Programs” on page 129 to run the
diagnostic utility.
PCNTNW-NW-180 The DMA parameter is not necessary for PCI device.
Explanation: The Ethernet controller does not require a DMA setting.
Action: Delete the DMA parameter from the NET.CFG file.
Novell NetWare DOS ODI Driver Messages
This section contains the error messages for the Novell NetWare
DOS ODI device driver. The explanation and recommended action
are included with each message.
Chapter 4. Solving Problems
157