IBM PC Server 325, User Handbook Manual

Page: 183 / 288

Ethernet Controller Messages
PCNTN3-21 Device not found.
Explanation: The driver cannot find any PCnet device.
Action: Perform the following steps:
1. Verify that the Ethernet enable jumper is set to the default Enable position.
2. Go to “About the Test Programs” on page 129 to run the diagnostic utility.
Packet Driver Messages
This section contains the error messages for the packet driver. The
explanation and recommended action are included with each
message.
PCNTPK-DOS-1 The command syntax is PCNTPK [-n] [-d] [-w]
<
INT=packet_int_no
>
[IRQ=int_no] [IOADDR=io_addr] [DMA=dma_no] [BUSTYPE=bus]
[DMAROTATE] [TP]
[LED0=xx] [BUSTYPE=bus] [LED0=xx]
[LED2=xx] [LED3=xx]
Explanation: The driver command was not entered correctly.
Action:
If you entered the command from the command line, enter the command
with the correct syntax. If the command is in the AUTOEXEC.NET file, edit the file
to correct the syntax. The only parameters that should be included are PCNTPK and
BUSTYPE=PCI1.
PCNTPK-DOS-2 Unable to reset the PCnet device.
Explanation: The software could not reset the Ethernet controller.
Action:
Perform the following steps:
1. Verify that the Ethernet enable jumper is set to the default (enable) position.
2. If the problem persists, go to “About the Test Programs” on page 129 to run the
diagnostic utility.
PCNTPK-DOS-3 Unable to initialize the PCnet device.
Explanation: The software could not initialize the Ethernet controller.
Action: Perform the following steps:
1. Verify that the Ethernet enable jumper is set to the default (enable) position.
2. Check the interrupt settings in the Configuration/Setup utility programs. For
more information, go to “PCI Bus Control” on page 33.
3. If the problem persists, go to “About the Test Programs” on page 129 to run the
diagnostic utility.
Chapter 4. Solving Problems
169