NOTE
l
The OLT's CVLAN must be the same as the upstream VLAN of the ONU.
l
Run the
service-port
to create service ports one by one. In this example, only one service port
is created as an example. When a service port is created, note that it must correspond to the GEM
port configured with the ONU line-profile and the CVLAN.
l
You can also run the
multi-service-port
command to create service ports in batches. In the case
of GPON access, you must set
ontid
+
gemindex
to specify a service port. In addition, the number
of GEM ports must be the same as the number of CVLANs.
9.
Configure the queue scheduling mode.
Adopt the 3PQ+5WRR queue scheduling. Queues 0-4 adopt the WRR mode and their
weights are 10, 10, 20, 20, and 40 respectively. Queues 5-7 adopt the PQ mode. The
priority of the Internet access service is 1, adopting the WRR mode.
NOTE
l
The queue scheduling mode is configured globally, and you need to configure it only once on
the OLT. After the configuration is complete, the queue scheduling mode takes effect globally.
When subsequent services are configured, you do not need to configure the queue scheduling
mode again.
l
For a board that supports only four queues, the default mapping between the 802.1p priorities
and queue IDs are as follows: priorities 0 and 1 map queue 1; priorities 2 and 3 map queue 2;
priorities 4 and 5 map queue 3; priorities 6 and 7 map queue 4.
huawei(config)#
queue-scheduler wrr 10 10 20 20 40 0 0 0
Configure the mapping between the queues and 802.1p priorities. Priorities 0-7 map
queues 0-7 respectively.
huawei(config)#
cos-queue-map cos0 0 cos1 1 cos2 2 cos3 3 cos4 4 cos5 5 cos6
6 cos7 7
10. Save the data.
huawei(config)#
save
l
Configure the ONU.
NOTE
The configuration on ONU 1 and ONU 2 is the same. Take configuration on ONU 1 for example.
1.
Log in to the ONU to perform the configuration.
On the OLT, use the management IP address of the ONU to log in to the ONU through
Telnet. User name:
root
(default). Password:
mduadmin
(default).
2.
Configure the traffic profile.
You can run the
display traffic table ip
command to query the traffic profiles existing
in the system. If the traffic profiles existing in the system do not meet the requirements,
you need to run the
traffic table ip
command to add a traffic profile.
Add traffic profile 8, and set the CIR to 4 Mbit/s. The priority for upstream packets
is 1. The downstream priority policy is scheduled by the priority that the packets bear.
huawei(config)#
traffic table ip index 8 cir 4096 priority 1 priority-
policy
tag-In-Package
3.
Create an SVLAN.
Create SVLANs 1001-1024 in batches whose type is smart and attribute is common.
Add SVLANs to upstream port 0/0/1.
SmartAX MA5616 Multi-service Access Module
Configuration Guide
10 Configuration Examples of the FTTx
Issue 04 (2011-10-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
508
