Parameter
Description
Default Setting
34
Indicates whether the MG
actively establishes or releases
the link for the BRA user after
the MGC initiates the in-service
or OOS request.
Numeral type. Range: 0-1.
l
0: Yes
l
1: No
Default value: 0.
35
Indicates the out of service
(OOS) and in-service mode of
the ISDN port.
l
When the OOS or in-service
in wildcard mode is
supported, the ISDN port
reports the in-service or
OOS, that is, reports only
one in-service or OOS
message in wildcard mode.
This effectively reduces the
messages between the MG
interface and the MGC.
l
When the in-service or OOS
in single channel mode is
supported, the ISDN port
reports the in-service or
OOS message over each
channel.
l
When both the in-service or
OOS in single channel mode
and the in-service or OOS in
wildcard mode are
supported, the in-service or
OOS message is reported
according to the actual
requirement or reported in
single channel mode.
Numeral type. Range: 0-2.
l
0: Indicates that both the OOS
or in-service in single channel
mode and the OOS or in-
service in wildcard mode are
supported.
l
1: Indicates that only the OOS
and in-service in single
channel mode is supported.
l
2: Indicates that only the OOS
and in-service in wildcard
mode is supported.
Default value: 1.
Procedure
Step 1
Enter the MG interface mode.
In global config mode, run the
interface h248
command to enter the MG interface mode.
Step 2
Configure software parameters.
Run the
mg-software parameter
command the software parameters required in the data plan.
Step 3
Check whether the software parameters are the same as those in the data plan.
Run the
display mg-software parameter
command to check whether the software parameters
of the MG interface are the same as those in the data plan.
----End
SmartAX MA5616 Multi-service Access Module
Configuration Guide
7 Configuring the Voice Service
Issue 04 (2011-10-30)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
226
