Ceragon FibeAir IP-20C, User Manual

Page: 169 / 597

FibeAir IP-20C/S/E User Guide
Ceragon Proprietary and Confidential Page 169 of 597
6.1.7
Enabling, Disabling, or Deleting Multiple Services
To enable, disable, or delete multiple services:
1 Select Ethernet > Services. The Ethernet Services page opens
(Figure 117).
2 Select the services in the Ethernet Services Configuration table, or select all
the services by selecting the check box in the top row.
To enable the selected services, in the Multiple Selection Operation
section underneath the Ethernet Services Configuration Table, select
Operational and click Apply.
To disable the selected services, in the Multiple Selection Operation
section underneath the Ethernet Services Configuration Table, select
Reserved and click Apply.
To delete the selected services, select Delete underneath the Ethernet
Services Configuration Table. Before deleting a service, you must
delete any service points attached to the service, as described in
Deleting a Service Point.
Figure 119: Multiple Selection Operation Section (Ethernet Services)
Note: When setting multiple services to Reserve state, make sure
to avoid setting the management service to Reserve state.
6.1.8
Viewing Service Details
To view the full service parameters:
1 Select Ethernet > Services. The Ethernet Services page opens
(Figure 117).
2 Select the service in the Ethernet Services Configuration table.
3 In the Ethernet Services page, click Service Details. The Ethernet
Services – Service Details page opens. The Service Details page contains
the same fields as the Add page (Figure 118). However, in the Service
Details page, these fields are read-only.