FibeAir IP-20C/S/E
User Guide
Ceragon Proprietary and Confidential
Page 186 of 597
Table 41: Physical Interface Status Parameters
Parameter
Definition
Interface location
The location of the interface.
Operational Status
Indicates whether the interface is currently operational (Up) or non-operational (Down).
Admin Status
Indicates whether the interface is currently enabled (Up) or disabled (Down). You can
enable or disable an interface from the Interface Manager page. See Enabling the
Interfaces (Interface Manager).
Media Type
The physical interface layer 1 media type.
Actual port speed
Displays the actual speed of the interface for the link as agreed by the two sides of the
link after the auto negotiation process.
Actual port duplex
Displays the actual duplex status of the interface for the link as agreed by the two sides
of the link after the auto negotiation process.
6.4
Configuring Automatic State Propagation
Automatic state propagation enables propagation of radio failures back to the
Ethernet port. You can also configure Automatic State Propagation to close the
Ethernet port based on a radio failure at the remote carrier.
Automatic state propagation is configured as pairs of interfaces. Each interface
pair includes a Monitored Interface and a Controlled Interface.
It is recommended to configure both ends of the link to the same Automatic
State Propagation configuration.
To configure an Automatic State Propagation interface pair:
1 Select Ethernet > Interfaces > Automatic State Propagation. The
Automatic State Propagation page opens.
Figure 129: Automatic State Propagation Page
