FibeAir IP-20C/S/E
User Guide
Ceragon Proprietary and Confidential
Page 16 of 597
ESD
This equipment contains components which are sensitive to “ESD” (Electro
Static Discharge). Therefore, ESD protection measures must be observed
when touching the IDU.
Anyone responsible for the installation or maintenance of the FibeAir IDU
must use an ESD Wrist Strap.
Additional precautions include personnel grounding, grounding of work
benches, grounding of tools and instruments, as well as transport and storage
in special antistatic bags and boxes.
Laser
Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
The optical interface must only be serviced by qualified personnel, who are
aware of the hazards involved to repair laser products.
When handling laser products the following precautions must be taken:
Never look directly into an open connector or optical cable.
Before disconnecting an optical cable from the optical transmitter, the
power should be switched off. If this is not possible, the cable must be
disconnected from the transmitter before it is disconnected from the
receiver.
When the cable is reconnected it must be connected to the receiver before
it is connected to the transmitter.
Special Requirements for North America
Grounding: This equipment is designed to permit connection between the
earthed conductor of the DC supply circuit and the earthing conductor at the
equipment.
Note:
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to part 15 of
the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful
interference in which case the user will be required to
correct the interference at his own expense.
Restricted Access Area: DC powered equipment should only be installed in a
Restricted Access Area.
!!
