FibeAir IP-20C/S/E
User Guide
Ceragon Proprietary and Confidential
Page 135 of 597
Parameter
Definition
Remote Radio Mute
To mute the TX output of the remote radio, select On. To unmute the TX
output of the remote radio, select Off.
Remote IP Address
The IPv4 IP address of the remote unit.
Remote IPv6 Address
The IPv6 IP address of the remote unit.
5.3
Configuring ATPC
ATPC is a closed-loop mechanism by which each radio adjusts its transmitted
signal power according to the indication received across the link, in order to
achieve a desired RSL on the other side of the link. Without ATPC, if loss of
frame occurs the system automatically increases its transmit power to the
configured maximum. This may cause a higher level of interference with other
systems until the failure is corrected.
To enable and configure ATPC and display ATPC settings:
1 Select Radio > ATPC. The ATPC page opens.
For IP-20C units, the Radio Parameters page initially displays a table as
shown in Figure 91.
For IP-20S units and IP-20E units, a page appears, similar to Figure 92
(which shows an IP-20C page).
Figure 91: ATPC Page
– IP-20C
2 For IP-20C units, select the carrier you wish to configure in the ATPC table
(see Figure 91) and click Edit. A separate ATPC –Edit page opens. The page
is essentially identical to the IP-20E and IP-20S page.
