FibeAir IP-20C/S/E
User Guide
Ceragon Proprietary and Confidential
Page 441 of 597
17.3.1
Entering Interface View (CLI)
To view interface details and set the interface’s parameters, you must enter
the interface’s view level in the CLI.
Use the following command to enter an Ethernet interface’s view level:
root> ethernet interfaces eth slot <slot> port <port>
Use the following command to enter the radio interface’s view level:
root> ethernet interfaces radio slot <slot> port <port>
Use the following command to enter the view level of a group, such as a Multi-
Carrier ABC group, an HSB protection group, or a LAG:
root> ethernet interfaces group <group>
Table 138: Entering Interface View CLI Parameters
Parameter
Input Type
Permitted Values
Description
size
Number
64 to 9612
Defines the global size (in bytes) of the
Maximum Receive Unit (MRU). Frames that
are larger than the global MRU will be
discarded.
slot
Number
Ethernet: 1
Radio: 2
Depends on the interface and unit type.
port
Number
GbE 1: 1
GbE 2: 2
GbE 3: 3
Radio Carrier 1: 1
Radio Carrier 2 (IP-
20C only): 2
The port number of the interface.
group
Variable
rp1
rp2
rp3
rp4
lag1
lag2
lag3
lag4
mc-abc1
mc-abc2
mc-abc3
mc-abc4
To enter interface view for a group, enter the
group ID for one of the following types of
group:
HSB group (rp1 - rp-4)
LAG (lag1 - lag4)
Multi-Carrier ABC group (mc-abc1 - mc-
abc4)
Note: HSB and Multi-Carrier ABC groups are
only relevant for IP-20C.
Example
The following command enters interface view for Ethernet port 3:
root> ethernet interfaces eth slot 1 port 3
