FibeAir IP-20C/S/E
User Guide
Ceragon Proprietary and Confidential
Page 361 of 597
Setting synchronization settings. Refer to Configuring SyncE Regenerator
(CLI)
To configure these settings in the standby unit, first enter the mate/root
context, as described in Performing CLI operations on the Standby unit (CLI),
then run the relevant commands, and then switch back to the active unit.
14.5.5.1 Performing CLI operations on the Standby unit (CLI)
You can run CLI commands in the standby unit.
To run CLI commands in the standby unit:
1 Use the following command to enter view context for the standby unit:
root> switch-to mate
mate/root>
2 Enter the specific CLI command you want to run in mate/root context.
3 To switch back to the active unit, enter the following command:
mate/root> switch-back
root>
14.5.6
Viewing Link and Protection Status and Activity (CLI)
You can view link and protection status and activity any time.
To view whether HSB protection is enabled or disabled, enter the
following command in root view:
root> platform management protection show admin
To view whether HSB protection is functional (available in practice), enter
the following command in root view. Note that protection is not functional
if MIMO is configured, or if the management connection to the mate is
down.
root> platform management protection show operational-state
To view protection activity, enter the following command in root view:
root> platform management protection show activity-state
To view the status of the protection link to the mate, enter the following
command in root view:
root> platform management protection show link-status
To view the status of the last copy-to-mate operation, enter the following
command in root view:
root> platform management protection show copy-to-mate status
To view the current lockout status, enter the following command in root
view:
root> platform management protection show lockout status
