FibeAir IP-20C/S/E
User Guide
Ceragon Proprietary and Confidential
Page 362 of 597
14.5.7
Manually Switching to the Standby Unit (CLI)
The following events trigger switchover for HSB radio protection according to
their priority, with the highest priority triggers listed first.
1 Loss of active unit
2 Lockout
3 Radio/Ethernet interface failure
4 Manual switch
At any point, you can manually switch to the Standby unit, provided that the
highest protection fault level in the Standby unit is no higher than the highest
protection fault level on the Active unit.
To manually switchover to the Standby unit enter the following command in
root view:
root> platform management protection set manual-switch
14.5.8
Disabling Automatic Switchover to the Standby Unit (CLI)
At any point, you can perform lockout, which disables automatic switchover to
the standby unit.
To disable automatic switchover to the Standby unit, use the following
command in root view:
root> platform management protection lockout set admin on
To re-enable automatic switchover to the standby unit, use the following
command in root view:
root> platform management protection lockout set admin off
14.5.9
Disabling Unit Protection (CLI)
You can disable unit protection at any time. If you disable unit protection,
keep in mind that while the unit that was formerly the active unit maintains its
IP address, the unit that was formerly the standby unit is assigned the default
IP address (192.168.1.1)
To disable protection, enter the following command in root view.
root> platform management protection set admin disable
