FibeAir IP-20C/S/E
User Guide
Ceragon Proprietary and Confidential
Page 157 of 597
2 In the Port field, select the port that holds the radio for which you want to
display PMs.
3 In the Interval Type field:
To display reports in 15-minute intervals, select 15 minutes.
To display reports in daily intervals, select 24 hours.
Table 31 describes the XPI PMs.
Note:
To display the same parameters for a specific interval in a
separate page, select the interval in the Modem XPI PM table
and click View.
Table 31: XPI PMs
Parameter
Definition
Interval
For 24-hour intervals, displays the date of the interval. For 15-minute
intervals, displays the date and ending time of the interval.
Min XPI (dB)
The minimum XPI level that was measured during the interval.
Max XPI (dB)
The maximum XPI level that was measured during the interval.
XPI below threshold seconds
The number of seconds the measured XPI level was below the threshold
during the interval. XPI thresholds are configured in the Radio Thresholds
page. See Configuring Radio Thresholds.
Integrity
Indicates whether the values received at the time and date of the measured
interval are reliable. An x in the column indicates that the values are not
reliable due to a possible power surge or power failure that occurred at that
time.
5.6.9
Displaying Traffic PMs
This section includes:
Displaying Capacity and Throughput PMs
Displaying Frame Error Rate PMs
5.6.9.1 Displaying Capacity and Throughput PMs
You can display PMs for capacity and throughput for a radio, based on:
The total Layer 1 bandwidth (payload plus overheads) sent through the
radio (Mbps).
The total effective Layer 2 traffic sent through the radio.
You can also configure thresholds for capacity and throughput PMs. The
number of seconds during which these thresholds are exceeded are among the
dispayed PMs.
To display capacity and throughput PMs per radio:
1 Select Radio > PM & Statistics > Traffic > Capacity/Throughput. The
Capacity PM report page opens.
