FibeAir IP-20C/S/E
User Guide
Ceragon Proprietary and Confidential
Page 179 of 597
6 Configure the service point attributes, as described in Table 36, Table 38,
and Table 39.
Note:
Optionally, you can select from a list of pre-defined service
point options in the Pre defined options field at the top of
the Ethernet Service Points - Add page. The system
automatically populates the remaining service point
parameters according to the system-defined parameters.
However, you can manually change these parameter values.
The pre-defined options are customized to the type of
service to which you are adding the service point.
7 Click Apply, then Close.
6.1.9.4 Editing a Service Point
To edit a service point:
1 Select Ethernet > Services. The Ethernet Services page opens
2 Select the relevant service in the Ethernet Services Configuration table.
3 Click Service Points. The Ethernet Service Points page opens (Figure 120).
4 Select the relevant service point in the Ethernet Services Points – General
SP Attributes table.
5 Click Edit. The Ethernet Service Points– Edit page opens. The Ethernet
Service Points – Edit page is similar to the Ethernet Service Points - Add
page (Figure 123). You can edit any parameter that can be configured in
the Add Service Point page, except Service Point ID, Service Point Type,
and the General SP Attributes.
6 Edit the service point attributes, as described in Table 36, Table 38, and
7 Click Apply, then Close.
6.1.9.5 Deleting a Service Point
You can only delete a service point with an Attached Interface Type of
Bundle-C or Bundle-S if no VLANs are attached to the service point. See
Attaching VLANs.
To delete a service point:
1 Select Ethernet > Services. The Ethernet Services page opens
2 Select the relevant service in the Ethernet Services Configuration table.
3 Click Service Points. The Ethernet Service Points page opens (Figure 120).
4 Select the relevant service point in the Ethernet Services Points – General
SP Attributes table.
5 Click Delete. The service point is deleted.
