FibeAir IP-20C/S/E
User Guide
Ceragon Proprietary and Confidential
Page 167 of 597
Figure 118: Ethernet Services - Add page
3 In the Service ID field, select a unique ID for the service. You can choose
any unused value from 1 to 1024. Once you have added the service, you
cannot change the Service ID. Service ID 1025 is reserved for a pre-defined
management service.
4 In the Service Type field, select the service type:
MP – Multipoint
MNG – Management
P2P – Point-to-Point
5 Optionally, in the EVC ID field, enter an Ethernet Virtual Connection (EVC)
ID (up to 20 characters). This parameter does not affect the network
element’s behavior, but is used by the NMS for topology management.
6 Optionally, in the EVC Description field, enter a text description of the
service (up to 64 characters). This parameter does not affect the network
element’s behavior, but is used by the NMS for topology management.
7 In the Admin field, select one of the following options:
Operational - The service is functional.
Reserved - The service is disabled until this parameter is changed to
Operational. In this mode, the service occupies system resources but
is unable to receive and transmit data.
8 In the MAC table size field, enter the maximum MAC address table size for
the service. The MAC address table is a source MAC address learning table
used to forward frames from one service point to another. You can select a
value from 16 to 131,072, in multiples of 16. This maximum only applies to
dynamic, not static, MAC address table entries.
Note:
Additional configuration of the MAC address table can be
performed via the CLI. See Defining the MAC Address
