Rohde & Schwarz 1145.1010.04/05/06, Руководство по эксплуатации

Страница: 86 / 813

Remote Control in a LAN R&S
®
ZVT
1300.0045.62 1.14 E-1
Advanced TCP/IP Settings dialog. Both instruments must have independent IP addresses; see section
Assigning an IP Address below. Contact your LAN administrator for details.
Attention!
Never use both LAN connectors to connect the analyzer in parallel to the same network
as this will result in connection errors.
Remote Control in a LAN
A LAN connection is used to integrate the analyzer into a home/company network. This offers several
applications:
•
Transfer data between a controller and the analyzer, e.g. in order run a remote control program.
•
Control the measurement from a remote computer using the Remote Desktop application.
•
Use external network devices (e.g. printers).
Attention!
An efficient virus protection is a prerequisite for secure operation in the network.
Never connect your analyzer to an unprotected network because this may cause
damage to the instrument software.
To establish the connection proceed as follows:
1. Press the Windows button and open Windows XP's control panel.
2. Select System and open the Remote tab in the System Properties dialog. Enable Allow users to
connect remotely to this computer.
3. Assign an IP address to the analyzer following the directions below and connect the analyzer to
the network as described in Connecting a LAN Cable .
4. Create a Remote Desktop Connection using the analyzer's IP address.
The analyzer uses a user name and password as credentials for remote access. In the factory
configuration, instrument is preset for both the user name and the password. To protect the
analyzer from unauthorized access, it is recommended to change the factory setting.
Assigning an IP Address
Depending on the network capacities, the TCP/IP address information for the analyzer can be obtained
in different ways.