Rohde & Schwarz 1145.1010.04/05/06, Руководство по эксплуатации

Страница: 662 / 813

SENSe R&S
®
ZVA/ZVB/ZVT
1145.1084.12 6.200 E-6
<port_no> Port numbers of the analyzer.
Note: If the analyzer is set to use the same connectors at all ports
(
[SENSe<Ch>:]CORRection:COLLect:CONNection<port_no>
:PORTs ALL
), then a change of a connector type is valid for all
ports. The gender of the connectors can still be different.
Parameters Connector type and gender of the connectors (omitted for query).
UFEMALE1 and UMALE1 denote the user-defined connector type
UserConn1, UFEMALE2 and UMALE2 denote the user-defined connector
type UserConn2. SMAFEMALE and SMAMALE denote the user-defined
connector type SMA. The user-defined connector types must be defined
before being addressed by
[SENSe<Ch>:]CORRection:COLLect:CONNection<port_no>.
*RST value N50FEMALE for all connectors.
SCPI,
Command
Types
Device-specific, command or query.
Example:
*RST; CORR:COLL:CONN1 N50MALE; CONN4?
Change the connector type at port 1 from
PC35FEMALE
to
N50MALE
. The
connector type at the other ports is also changed to N50, however, the
gender (female) is maintained.
CORR:COLL:CONN4?
returns
N50FEMALE
.
[SENSe<Ch>:]CORRection:COLLect:CONNection:PORTs ALL | SINGle
Qualifies whether the connector types at the analyzer ports (but not their gender) are equal or
independent.
In the present firmware version, a calibration must be performed using the same connector type
at all ports. Use [SENSe<Ch>:]CORRection:COLLect:CONNection<port_no>:PORTs SINGle if
you want to perform a
measurement with independent port connectors.
<Ch> Channel number of the calibrated channel.
Parameters ALL: Equal (uniform) connector types. If the connector type at one
port is changed, the connector type at all other ports is changed
accordingly.
SINGle: Independent (possibly non-uniform) connector types at the
ports.
<port_no> Port numbers of the analyzer. This parameter has no effect because
the setting affects all ports.
*RST value ALL
SCPI,
Command
Types Device-specific, command or query.
Example:
CORR:COLL:CONN:PORTS SING
Select independent connector types at the ports.
CORR:COLL:CONN1 N50MALE; CONN4 N75FEMALE; CONN2?
Select independent connector types at ports 1 and 4. The connector
type at port 2 is not changed; the query returns N50FEMALE.