Rohde & Schwarz 1145.1010.04/05/06, Руководство по эксплуатации

Страница: 665 / 813

R&S
®
ZVA/ZVB/ZVT SENSe
1145.1084.12 6.203 E-6
Example:
CORR:COLL:METH REFL1
Select a one-port normalization at port 1 as calibration type.
CORR:COLL OPEN1
Measure an open standard connected to port 1 and store the
measurement results of this standard.
CORR:COLL:SAVE
Calculate the system error correction data and apply them to the
active channel.
[SENSe<Ch>:]CORRection:COLLect:SAVE:DEFault
Generates a set of default system error correction data for the selected ports and calibration type. The
default data set corresponds to a test setup which does not introduce any systematic errors; none of the
measurement results acquired previously (
[SENSe<Ch>:]CORRection:COLLect[:ACQuire])
is
taken into account.
The main purpose of the default correction data set is to provide a dummy system error
correction which you can replace with your own, external correction data. You may have acquired the
external data in a previous session or even on an other instrument. If you want to use the external
correction data on the analyzer, simply generate the default data set corresponding to your port
configuration and calibration type and overwrite the default data. For details refer to the program
example below.
This command must be used in combination with the ZVR-compatible commands
[SENSe<Ch>:]CORRection:COLLect:METHod and [SENSe<Ch>:]CORRection:DATa. Use
[SENSe<Ch>:]CORRection:COLLect:SAVE:SELected:DEFault if you want to use ZVA-specific
calibration commands or if you want to calibrate more than 2 ports.
<Ch> Channel number of the calibrated channel.
*RST value –
SCPI,
Command
Types Device-specific, no query