Rohde & Schwarz 1145.1010.04/05/06, Руководство по эксплуатации

Страница: 6 / 813

1145.1084.02 RE.6 E-6
Improvements in Firmware V1.78 (Compared to V1.77)
ƒ
Performance improvements for very large numbers of simultaneous channels/traces
New Features in Firmware V1.77 (Compared to V1.75)
ƒ
New calibration standard: Sliding match.
ƒ
The 7-term calibration types TOM , TRM, TRL, and TNA can be used for an arbitrary number of
ports.
ƒ
Two new calibration types: TSM Enhanced and TOM Enhanced.
ƒ
Sweep segment-specific IF gain for received waves including Automatic Gain Control (AGC).
New Features in Firmware V1.75 (Compared to V1.70)
ƒ
The channel bits are switched over without intermediate reset when the measuring channel is
changed. The bits always correspond to the current measuring channel.
ƒ
During a calibration sweep the channel bits of the calibrated channel are activated (instead of
the reset values).
ƒ
When a new channel is created, the channel bits automatically take on the values of the
previous channel.
ƒ
Calibration via remote control works for all channels without restriction.
ƒ
Touchstone files for more than 4 (and up to 8) ports are supported.
ƒ
A measurement wizard for up to 4 ports is available for ZVT analyzers.
ƒ
Automatic calibration works correctly after a balanced port configuration is configured in the
measurement wizard.
New Features in Firmware V1.70 (Compared to V1.62)
ƒ
New measurement: Virtual Transform (Embedding/De-Embedding)
ƒ
Sweep range can be defined by Sweep Step Size
ƒ
Alternative conversion of wave quantities in trace mathematics
ƒ
Data to Memory function can be applied to all data traces at once
ƒ
New softkey Recall Last Cal Set
ƒ
Export of formatted trace data
ƒ
Renormalization of reference impedances for the test ports with complex values