Rohde & Schwarz 1145.1010.04/05/06, Руководство по эксплуатации

Страница: 79 / 813

R&S
®
ZVT Putting the Instrument into Operation
1300.0045.62 1.7 E-1
Should the instrument be damaged, immediately notify the forwarder who shipped the instrument to you
and keep the container and packing material.
Equipment returned or sent in for repair must be packed in the original container or packing with
electrostatic protection. It is recommended to keep at least the two protective caps for front and rear
side in order to prevent damage to the controls and connectors.
Instrument Setup
The network analyzer is designed for use under laboratory conditions, either on a bench top or in a
rack. The general ambient conditions required at the operating site are as follows:
•
The ambient temperature must be in the ranges specified for operation and for compliance with
specifications (see data sheet).
•
All fan openings including the rear panel perforations must be unobstructed. The distance to the
wall should be at least 10 cm.
Attention!
To avoid damage of electronic components of the DUT and the analyzer, the
operating site must be protected against electrostatic discharge (ESD). ESD is
most likely to occur when you connect or disconnect a DUT or test fixture to the
analyzer's test ports.
To prevent ESD damage use the wrist strap and grounding cord supplied with the
instrument and connect yourself to the GND connector at the front panel.
Bench Top Operation
If the analyzer is operated on a bench top, the surface should be flat. The instrument can be used in
horizontal position, standing on its feet.
Mounting in a 19" Rack
Using the adapter ZZA-611 (order number 1096.3302.00) the instrument can be mounted in 19" racks
according to the mounting instructions supplied with the rack adapter.
Attention!
•
Allow for sufficient air supply in the rack.
•
Make sure that there is sufficient space between the ventilation holes and the
rack casing.