Rohde & Schwarz 1145.1010.04/05/06, Руководство по эксплуатации

Страница: 657 / 813

R&S
®
ZVA/ZVB/ZVT SENSe
1145.1084.12 6.195 E-6
*RST value – (A *RST does not change the assignment between connector types
and calibration kits.)
SCPI,
Command
Types
Device-specific, command or query
Example:
MMEM:LOAD:CKIT
'C:\Rohde&Schwarz\NWA\Calibration\Kits\New_kit.calkit
'
Load the previously created cal kit file
New_kit.calkit from the default cal kit directory.
C
ORR:CKIT:N50:SEL 'New_kit'
Assign the imported kit to the N 50
Ω
connector type (assuming that the
cal kit name stored in
New_kit.calkit
reads New_kit.
Cal kit naming conventions
Calibration kit names must be entered as string parameters. The string contains the cal kit name used
in the
Calibration Kits dialog; a
Ω
in the name must be replaced by 'Ohm', e.g.:
ƒ
'NewKit1' denotes the user-defined calibration kit NewKit1 .
ƒ
'N 50 Ohm Dummy Kit' denotes the N 50
Ω
Dummy Kit .
ƒ
'ZV-Z21 typical' denotes the cal kit ZV-Z21 typical .
[SENSe<Ch>:]CORRection:CKIT:INSTall '<file_name>'
Loads cal kit data from a specified ZVR cal kit file.
<Ch>
Channel number. This suffix is ignored because calibration kits are
channel-independent.
'<file_name>' String parameter to specify the name and directory of the cal kit file to
be loaded.
Note: The loaded file must be a ZVR-specific cal kit file with the
extension *.ck. NWA cal kit files (*.calkit) can be imported using
the
MMEMory:LOAD:CKIT
command. Agilent cal kit files can be
imported manually and converted into *.calkit files.
*RST value –
SCPI,
Command
Types Device-specific, no query.