Dell Networking Z9500, Справочник по командам

Страница: 625 / 1905

Use the
dcb-map
command to create a DCB map to specify PFC and ETS settings
and apply it on Ethernet ports. After you apply a DCB map to an interface, the PFC
and ETS settings in the map are applied when the Ethernet port is enabled. DCBx is
enabled on Ethernet ports by default.
The
dcb-map
command is supported only on physical Ethernet interfaces.
To remove a DCB map from an interface, enter the
no dcb-map map-name
command in Interface configuration mode.
dcb-map sfm all backplane all
Assign the specified DCB Map on all backplane ports of the switch linecard.
Syntax
dcb-map sfm all backplane all <dcb-map-name>
Parameters
map-name Enter a DCB map name. The maximum number of
alphanumeric characters is 32.
Defaults none
Command
Modes GLOBAL CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the Z9500.
Usage
Information
You can configure DCB-MAP on backplane ports in both leaf and spine. To remove
a DCB Map from all backplane ports. To remove a DCB Map from all backplane
ports, enter the
[no] dcb-map sfm all backplane all <dcb-map-name>
command in Interface configuration mode.
Data Center Bridging (DCB)
625