Dell Networking Z9500, Справочник по командам

Страница: 960 / 1905

Related
Commands hash-algorithm ecmp — changes the hash algorithm across an ECMP.
management route
Configure a static route that points to the Management interface or a forwarding router.
Z9500
Syntax
management route {{ ip-address mask | { ipv6-address prefix-
length }} { forwarding-router-address | managementethernet |
fortyGigE | vlan | tengigabitethernet}
To remove a static route, use the
no management route{{ ip-address mask
| { ipv6-address prefix-length }}{ forwarding-router-address |
managementethernet | fortyGigE | vlan | gigabitethernet |
tengigabitethernet}
command.
Parameters
ip-address
mask Enter an IP address (dotted decimal format) and mask (/prefix
format) of the destination subnet.
ipv6-address
prefix-length Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix
format) of the destination subnet. Enter the IPv6 address in
the x:x:x:x::x format followed by the prefix length in the /x
format.
The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
forwarding-
router-address Enter an IP address (dotted decimal format) or an IPv6
address (x:x:x:x::x format) of a forwarding router.
managementet
hernet Enter the keyword
managementethernet
for the
Management interface on the Primary RPM.
fortyGigE Enter the keyword
fortyGigE
to specify a forty Gigbit
Ethernet interface.
vlan Enter the keyword
vlan
to specify a vlan interface.
tengigabitether
net Enter the keyword tengigabitethernet to specify a ten Gigabit
Ethernete interface.
Defaults Not configured.
Command
Modes CONFIGURATION
960
IPv4 Routing