Dell Networking Z9500, Справочник по командам

Страница: 430 / 1905

Version Description
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
When you apply a route map to outbound routes, only routes that match at least
one section of the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the
characteristics in the Route map used in this command. If you identify a peer by IP
address, the Route map overwrites either the inbound or outbound policies on that
peer.
neighbor route-reflector-client
Configure the router as a route reflector and the specified neighbors as members of the cluster.
Z9500
Syntax
neighbor { ip-address | peer-group-name } route-reflector-client
To remove one or more neighbors from a cluster, use the
no neighbor { ip-
address | peer-group-name } route-reflector-client
command. If you
delete all members of a cluster, you also delete the route-reflector configuration
on the router.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name Enter the name of the peer group.
All routers in the peer group receive routes from a route
reflector.
Defaults Not configured.
Command
Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
430
Border Gateway Protocol