Dell Networking Z9500, Справочник по командам

Страница: 57 / 1905

2. Enter the
protocol spanning-tree mstp
command. The prompt changes to include (conf-
mstp).
You can return to CONFIGURATION mode by using the
exit
command.
OPENFLOW INSTANCE Mode
To enable and configure OpenFlow instances, use OPENFLOW INSTANCE mode.
To enter OPENFLOW INSTANCE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the
openflow of-instance
command then the OpenFlow ID number of the instance you
want to create or configure. The prompt changes to include (conf-of-instance of-id ).
You can return to the CONFIGURATION mode by entering the exit command.
Per-VLAN SPANNING TREE (PVST+) Plus Mode
To enable and configure the Per-VLAN Spanning Tree (PVST+) protocol, use PVST+ mode. For more
information, refer to
Per-VLAN Spanning Tree Plus (PVST+) .
NOTE: The protocol name is PVST+, but the plus sign is dropped at the CLI prompt.
To enter PVST+ mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the
protocol spanning-tree pvst
command. The prompt changes to include (conf-
pvst).
You can return to CONFIGURATION mode by using the
exit
command.
PORT-CHANNEL FAILOVER-GROUP Mode
To configure shared LAG state tracking, use PORT-CHANNEL FAILOVER-GROUP mode. For more
information, refer to
Port Channel Commands .
To enter PORT-CHANNEL FAILOVER-GROUP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the
port-channel failover-group
command. The prompt changes to include (conf-po-
failover-grp).
You can return to CONFIGURATION mode by using the
exit
command.
PREFIX-LIST Mode
To configure a prefix list, use PREFIX-LIST mode.
To enter PREFIX-LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the
ip prefix-list
command. Include a name for the prefix list. The prompt changes to
include (conf-nprefixl).
You can return to CONFIGURATION mode by using the
exit
command.
CLI Basics
57