Dell Networking Z9500, Справочник по командам

Страница: 330 / 1905

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Related
Commands
set automatic-tag — computes the tag value of the route.
set level — specifies the OSPF area for route redistribution.
set metric — specifies the metric value assigned to redistributed routes.
set metric-type — specifies the route type assigned to redistributed routes.
set weight
To add a non-RFC compliant attribute to the BGP route to assist with route selection, configure a filter.
Z9500
Syntax
set weight weight
To delete a weight specification, use the
no set weight weight
command.
Parameters
weight Enter a number as the weight used by the route meeting the
route map specification. The range is from 0 to 65535. The
default is router-originated =
32768 and all other routes = 0 .
When there are multiple routes to the same destination, the
routes with a higher weight are preferred.
Defaults router-originated = 32768 ; all other routes = 0
Defaults Not configured.
Command
Modes ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
330
Access Control Lists (ACL)