Dell Networking Z9500, Справочник по командам

Страница: 56 / 1905

LLDP MANAGEMENT INTERFACE Mode
To enable and configure Link Layer Discovery Protocol (LLDP) on management interfaces, use LLDP
MANAGEMENT INTERFACE mode.
To enter LLDP MANAGEMENT INTERFACE mode:
1. Verify that you are logged in to LLDP mode.
2. Enter the
management-interface
command. The prompt changes to include (conf-lldp-mgmtIf).
LINE Mode
To configure the console or virtual terminal parameters, use LINE mode.
To enter LINE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the
line
command. Include the keywords
console
or
vty
and their line number available on
the switch. The prompt changes to include (config-line-console) or (config-line-vty).
You can exit this mode by using the
exit
command.
MAC ACCESS LIST Mode
To enter MAC ACCESS LIST mode and configure either standard or extended access control lists (ACLs),
use the
mac access-list standard
or
mac access-list extended
command.
To enter MAC ACCESS LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Use the
mac access-list standard
or
mac access-list extended
command. Include a
name for the ACL. The prompt changes to include (conf-std-macl) or (conf-ext-macl).
You can return to CONFIGURATION mode by using the
exit
command.
MONITOR SESSION Mode
To enable and configure a traffic monitoring session using port monitoring, use MONITOR SESSION
mode. For more information, refer to
Port Monitoring .
To enter MONITOR SESSION mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the
monitor session
command then the session ID. The prompt changes to include (conf-
mon-sess- sessionID ).
MULTIPLE SPANNING TREE (MSTP) Mode
To enable and configure MSTP, use MULTIPLE SPANNING TREE mode. For more information, refer to
Multiple Spanning Tree Protocol (MSTP) .
To enter MULTIPLE SPANNING TREE mode:
1. Verify that you are logged in to CONFIGURATION mode.
56
CLI Basics