Dell Networking Z9500, Справочник по командам

Страница: 385 / 1905

bgp router-id
Assign a user-given ID to a BGP router.
Z9500
Syntax
bgp router-id ip-address
To delete a user-assigned IP address, use the
no bgp router-id
command.
Parameters
ip-address Enter an IP address in dotted decimal format to reset only
that BGP neighbor.
Defaults The router ID is the highest IP address of the Loopback interface or, if no Loopback
interfaces are configured, the highest IP address of a physical interface on the
router.
Command
Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
Peering sessions are reset when you change the router ID of a BGP router.
bgp soft-reconfig-backup
To avoid the peer from resending messages, use this command only when route-refresh is not
negotiated.
Z9500
Syntax
bgp soft-reconfig-backup
To return to the default setting, use the
no bgp soft-reconfig-backup
command.
Border Gateway Protocol
385