Dell Networking Z9500, Справочник по командам

Страница: 1028 / 1905

Example
Dell(conf)# ipv6 unicast-host-route
Warning: Command will take effect for existing routes only
when IPv6
route prefixes are cleared from RTM
Dell(conf)#no ipv6 unicast-host-route
Warning: Command will take effect for existing routes only
when IPv6
route prefixes are cleared from RTM
Dell(conf)#
ipv6 unicast-routing
Enable IPv6 Unicast routing.
Z9500
Syntax ipv6 unicast-routing
To disable unicast routing, use the
no ipv6 unicast-routing
command.
Defaults Enabled
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.4.2.1 Introduced on the S-Series.
8.2.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information Because this command is enabled by default, it does not appear in the running
configuration. When you disable unicast routing, the
no ipv6 unicast-routing
command is included in the running configuration. Whenever unicast routing is
disabled or re-enabled, the system generates a syslog message indicating the
action.
1028
IPv6 Basics