Dell Networking Z9500, Справочник по командам

Страница: 790 / 1905

Example (2
Summary)
Dell#show frrp 2 summary
Dell#show frrp 2 summary
Ring-ID State Mode Ctrl_Vlan Member_Vlans
-----------------------------------------------
2 Up Master 2 11-20, 25, 27-30
Dell#
Related
Commands protocol frrp — enters the resilient ring protocol and designate a ring identification.
timer
Set the hello interval or dead interval for the Ring control packets.
Syntax
timer {hello-interval milliseconds }| {dead-interval
milliseconds }
To remove the timer, use the
no timer {hello-interval
[ milliseconds ]}| {dead-interval milliseconds }
command.
Parameters
hello-interval
milliseconds
Enter the keyword
hello-interval
then the time, in
milliseconds, to set the hello interval of the control packets.
The milliseconds must be entered in increments of 50
millisecond; for example, 50, 100, 150, and so on. If an
invalid value is entered, an error message is generated. The
range is from 50 to 2000 ms. Default:
500 ms .
dead-interval
milliseconds
Enter the keyword
dead-interval
then the time, in
milliseconds, to set the dead interval of the control packets.
The range is from 50 to 6000 ms. Default:
1500 ms .
NOTE: The configured dead interval must be at least
three times the hello interval.
Defaults
• 500 ms for
hello-interval milliseconds
• 1500 ms for
dead-interval milliseconds
Command
Modes CONFIGURATION (conf-frrp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
790
Force10 Resilient Ring Protocol (FRRP)