Dell Networking Z9500, Справочник по командам

Страница: 867 / 1905

Version Description
9.1(0.0) Updated ManagementEthernet output to include two global
IPv6 addresses on S4810 and Z9000 and added output
example showing OpenFlow instance ID.
8.3.12.1 Updated command output to support multiple IPv6
addresses on S4810.
8.3.11.4 Output expanded to support eSR4 optics in Z9000.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.2.1.2 Included SFP and SFP+ optics power detail in the E-Series
and C-Series output.
8.2.1.0 Added support for 4093 VLANs on the E-Series ExaScale.
Prior releases supported 2094.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Output expanded to include SFP+ media on the C-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Changed the organization of the display output.
6.3.1.0 Added the Pluggable Media Type field in the E-Series
TeraScale output.
Usage
Information
Use the
show interfaces
command for details on a specific interface. Use the
show interfaces linecard
command for details on all interfaces on the
designated line card.
NOTE: In the CLI output, the power value is rounded to a 3-digit value. For
receive/transmit power that is less than 0.000, an
snmp query
returns the
corresponding dbm value even though the CLI displays as 0.000.
NOTE: After the counters are cleared, the line-rate continues to increase until
it reaches the maximum line rate. When the maximum line rate is reached,
there is no change in the line-rate.
User
Information
The following table describes the
show interfaces
command shown in the 10G
example below.
Line Description
TenGigabitEthern
et 0/0... Interface type, slot/port, and administrative and line
protocol status.
Hardware is... Interface hardware information, assigned MAC address, and
current address.
Interfaces
867