Dell Networking Z9500, Справочник по командам

Страница: 919 / 1905

To remove the match filter for the crypto map, use the
no match seq-num tcp
[ source ip address | ipv6 address { mask } { source-port number }]
[ destination ip address | ipv6 address { mask } { destination-port
number }]
command.
Parameters
seq-num Enter the match command sequence number.
source ip-
address | ipv6
address
Enter the keyword
source
then the IPv4 or IPv6 address for
the source.
mask Enter the mask prefix length in /nn format.
source-port
number Enter the source port number.
destination-
port number Enter the destination port number.
Defaults none
Command
Modes CONFIG-CRYPTO-POLICY
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the Z9000, S4810, and S4820T.
Usage
Information
• IPv4 addresses support only -/32 mask types.
• IPv6 addresses support only -/128 mask types.
• Configure match for bi-directional traffic for optimal routing.
• Only TCP is supported.
Example
match 0 tcp a::1 /128 0 a::2 /128 23
match 1 tcp a::1 /128 23 a::2 /128 0
match 2 tcp a::1 /128 0 a::2 /128 21
match 3 tcp a::1 /128 21 a::2 /128 0
match 4 tcp 1.1.1.1 /32 0 1.1.1.2 /32 23
match 5 tcp 1.1.1.1 /32 23 1.1.1.2 /32 0
match 6 tcp 1.1.1.1 /32 0 1.1.1.2 /32 21
match 7 tcp 1.1.1.1 /32 21 1.1.1.2 /32 0
Internet Protocol Security (IPSec)
919