Dell Networking Z9500, Справочник по командам

Страница: 240 / 1905

[fragments] [log [interval minutes ] [threshold-in-msgs [count]]
[monitor]
To remove this filter, you have two choices:
• Use the
no seq sequence-number
command if you know the filter’s
sequence number.
• Use the
no deny tcp { source mask | any | host ip-address }
{ destination mask | any | host ip-address }
command.
Parameters
source Enter the IP address of the network or host from which the
packets are sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or non-contiguous.
any Enter the keyword
any
to specify that all routes are subject
to the filter.
host ip-address Enter the keyword
host
then the IP address to specify a host
IP address.
dscp Enter this keyword
dscp
to deny a packet based on the
DSCP value. The range is from 0 to 63.
bit Enter a flag or combination of bits:
•
ack:
acknowledgement field
•
fin:
finish (no more data from the user)
•
psh:
push function
•
rst:
reset the connection
•
syn:
synchronize sequence numbers
•
urg:
urgent field
operator (OPTIONAL) Enter one of the following logical operand:
•
eq
= equal to
•
neq
= not equal to
•
gt
= greater than
•
lt
= less than
•
range
= inclusive range of ports (you must specify two
ports for the
port
command)
port port
Enter the application layer port number. Enter two port
numbers if using the range logical operand. The range is
from 0 to 65535.
The following list includes some common TCP port
numbers:
• 23 = Telnet
240
Access Control Lists (ACL)