Dell Networking Z9500, Справочник по командам

Страница: 892 / 1905

NOTE: The implementation of LAG or Port Channel requires that you configure a LAG on both
switches manually. For information about the link aggregation control protocol (LACP) for dynamic
LAGs, refer to the
Link Aggregation Control Protocol (LACP) chapter. For more information about
configuring and using Port Channels, refer to the Dell Networking OS Configuration Guide .
channel-member
Add an interface to the Port Channel, while in INTERFACE PORTCHANNEL mode.
Z9500
Syntax
channel-member interface
To delete an interface from a Port Channel, use the
no channel-member
interface
command.
Parameters
interface (OPTIONAL) Enter any of the following keywords and slot/
port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
Defaults Not configured.
Command
Modes INTERFACE PORTCHANNEL
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.0 Introduced on the E-Series.
892
Interfaces