Dell Networking Z9500, Справочник по командам

Страница: 1826 / 1905

member
Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the
vlan-stack
compatible
command in its configuration.
Z9500
Syntax
member interface
To remove an interface from a Stackable VLAN, use the
no member interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords
port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/ port information.
Defaults Not configured.
Command
Modes CONF-IF-VLAN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
8.2.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the C-Series and S-Series.
Usage
Information You must enable the stackable VLAN (using the
vlan-stack compatible
command) on the VLAN prior to adding a member to the VLAN.
Related
Commands vlan-stack compatible — enables stackable VLAN on a VLAN.
1826
VLAN Stacking