Dell Networking Z9500, Справочник по командам

Страница: 79 / 1905

Version Description
7.7.1.0 Added support for TFTP and SCP.
7.6.1.0 Introduced on the S-Series.
Usage
Information
A system message displays with status information about the bootflash upgrade.
RFC 3986 specifies that IPv6 host addresses in a uniform resource identifier (URI)
must be enclosed in square brackets, [X:X:X:X::X]. For maximum flexibility this
command accepts IPv6 host addresses with or without the square brackets.
Reload the system after executing this command.
Example
Dell# upgrade boot all system all booted
Current Boot information in the system:
============================================
Card BootFlash Current Version New Version
---------------------------------------------------------------
---------
Linecard0 Boot Flash 3.2.1.0 3.2.1.0
Linecard1 Boot Flash 3.2.1.0 3.2.1.0
Linecard2 Boot Flash 3.2.1.0 3.2.1.0
***************************************************************
********
* Warning - Upgrading boot flash is inherently risky and
should only *
* be attempted when necessary. A failure at this upgrade may
cause *
* a board RMA. Proceed with caution ! *
***************************************************************
********
Dell#
upgrade fpga-image linecard booted
Use this command to upgrade the FPGA and CPLD devices in Z9500 line-card CPUs using the currently
running Dell Networking operating-system image (and only when required by the upgrade procedure in
the Z9500 release notes).
Z9500
Syntax
upgrade fpga-image linecard { slot-id | all} booted
Parameters
linecard slot-id Enter the slot ID number to specify the line-card CPU to
upgrade. The range of Z9500 slot IDs is 0 to 2. Enter
linecard all
to upgrade all Z9500 line cards.
Defaults none
File Management
79