Dell Networking Z9500, Справочник по командам

Страница: 206 / 1905

dot1x server-timeout
Configure the amount of time after which exchanges with the server time-out.
Z9500
Syntax
dot1x server-timeout seconds
To return to the default, use the
no dot1x server-timeout
command.
Parameters
seconds Enter a time-out value in seconds. The range is from 1 to
300, where 300 is implementation dependant. The default is
30 .
Defaults 30 seconds
Command
Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the C-Series and S-Series.
7.4.1.0 Introduced on the E-Series.
Usage
Information
When you configure the
dot1x server-timeout
value, take into account the
communication medium used to communicate with an authentication server and
the number of RADIUS servers configured. Ideally, the
dot1x server-timeout
value (in seconds) is based on the configured RADIUS-server timeout and
retransmit values and calculated according to the following formula:
dot1x
server-timeout
seconds > (radius-server retransmit seconds + 1) * radius-server
timeout seconds .
Where the default values are as follows:
dot1x server-timeout
(30 seconds),
radius-server retransmit (3 seconds), and radius-server timeout (5 seconds).
For example:
Dell(conf)#radius-server host 10.11.197.105 timeout 6
Dell(conf)#radius-server host 10.11.197.105 retransmit 4
206
802.1X